Step 1
CLEANING

Be sure the surface is free from oily or greasy residues or wax. It is recommended to properly clean the surface with a degreaser cleaner such as Fini-tech Surface Treatment.

A good cleaning eases the sanding and the scouring.

Note: If you use a scouring solution, it is very important to properly neutralize the surface before applying the finish.

Step 2
SANDING

• If possible, sand completely following wood grain using a 120 grit sandpaper (do not use steel wool). A good sanding assures a smooth surface and a good adherence.
  
• Remove dust completely using damp towels in order to not leave any residues in the finish.
  
• It is recommended to use a sanding block for flat surfaces.

Recoating (restoration):

For recoating, buff the finish using a 120 grit sandpaper in order to remove entirely the shine of the previous finish (top coat). Eliminate dust and apply 2 coats of varnish.

Step 3
STAIN, PAINT & FAUX-FINISH

Follow manufacturer's recommendations for the application of stain and faux-finish. Generally, before applying the finish, the drying time of water based stains is 24 hours and 48 hours for oil based stains. Fini-tech finishes are compatible with the majority of water and oil based products. Proceed first to an adherence test.

Step 4
APPLICATION

Application must be done at room temperature between 21° and 25° C (70° and 77° F) and at a relative humidity of 45%.

Bare wood:

1. Apply on a dry and clean bare wood (see SANDING).
   
2. Proceed to an adherence, color and compatibility test by reproducing jobsite application conditions and methods.
   
3. Apply 3 to 4 coats of the chosen Fini-tech finish with the following application method:
    
   1. Shake the finish vigorously for 45 seconds and let stand 10 minutes to allow bubbles to break. In order to provide a homogeneous finish, use a clean stick.
      
   1. If possible, spread a uniform coat following wood grain (do the whole application following the same direction) using the applicator. Smooth out marks and lines on the finish for a uniform application.
      
   2. Allow 2 to 3 hours of drying between coats (may vary according to conditions).
      
   3. Sand between coats using a 180 grit sandpaper.
      
   4. Do not sand before the last coat if the time between applications does not exceed 3 hours.
   5. Clean tools with water.

Recoating (restoration):

Appropriate for the majority of oil or water based finishes. It is important to remove completely all shine of the wood (top coat). Apply 1 or 2 coats of the chosen Fini-tech finish with the following application method.

APPLICATOR

Choice of the right applicator:

brush, foam brush,
Fini-tech finish applicator or a roll

QUICK TIPS

• Work during daylight to avoid any imperfections.
  
• In order to prevent warp, apply at least one coat on every surface, even inside the drawers.
  
• To prevent marks and bubbles, apply finish until a wet look is acheived. Use a new applicator and keep an angle of 45°. Follow recommended drying time between coats.
  
• For furniture and woodworks maintenance, use Fini-tech cleaning products.
• Use Finitec felt pads to protect the finish from decorative furniture.