 |
 |
 |
 |
Enhances the beauty of your dull and worn floor. Gives back a sparkling luster to your laminate and hardwood floors.
- Without sanding
- Odorless
- Can be applied over all types of finishes
- Ready to use - easy to apply
- Temporary solution (12 to 18 months)
- Very gloss
Gloss (90%)
VOC: 28 g/L
Covers approximately: 400 sq.ft./L (37 m²/L)
Available size: 1 L
Drying time:
Light traffic: 2 to 4 hours
Replace furniture: 24 hours
Replace rugs and carpets: 28 days
First cleaning: 28 days
Refreshes the luster of your wood floors
- Without sanding
- Odorless
- Ready to use - easy to apply
- Can be applied over all types of finishes
- Permanent solution, to be repeated every 2 years
- For optimal results, use Fini-tech Surface treatment as first step.
Gloss (85%) – Satin (35%)
VOC: 178 g/L (gloss) - 140 g/L (satin)
Covers approximately: 400
sq.ft./L (37 m²/L)
Available sizes: 1L, 1.8L
Drying time:
Between coat: 2 to 3 hours
Light traffic: 4 hours
Replace furniture: 24 hours
Replace rugs and carpets: 28 days
First cleaning: 28 days
Ideal for spring cleaning and surface preparation; removes oily and greasy residues.
- First step of the Fini-tech Restorer
- Ready to use - easy to apply
- Works within 5 minutes
- Can be used with the Fini-tech applicator
- Odorless
VOC: 20 g/L
Covers approximately: 400 sq.ft./L (37 m²/L)
Available sizes: 1L, 1.8L
Designed for the replacement or the restoration of a plank, stair or furniture section. Colors the new or sanded wood area to match the yellowish look of the old wood.
- Dyeing with alcohol with fast drying
- Use only on bare wood
Covers approximately: 11 sq.ft./250 mL (1 m²/250
mL)
Available sizes: 115 mL, 250 mL
High quality wood patch. Designed to fill CRACKS, NAIL HOLES and IMPERFECTIONS found in hardwood flooring.
- Odorless
- Trowel applicable
- Easy to sand
- Non-shrinking
- Compatible with wood stains
- Absorbs stains at the same rate as hardwood
Colors: Maple, Birch, Oak
Covers approximately: 83 to 137 sq.ft./L (8 à 12 m²/L)
Available sizes: 125 mL, 500 mL, 3.78L et 12L
Designed for installation and repair of hardwood and laminate floors and also to glue stairs component and woodworking.
- Fast drying and quick grabbing
- Dried glue is easily removable
Covers approximately: 50 sq.ft./L (4.6 m²/L) ou 400 pi linear/L (10 m linear/L)
Available sizes: 350 mL, 3.64L et 8L
|
Water based |  |
Uralkyd | |
Can be applied with a Fini-tech applicator |
|
Quick drying and odorless | |
Can be applied with a 10 mm roller | |
Non toxic and low VOC |
 |
Can be applied with a T-Bar |
 |
Technological breakthrough |  |
The most resistant of the industry |
 |
Quick curing time | |
Can be applied over an old oil or water based finish | |
Can be applied with a brush |
 |
Does not reflect the light |  |
Non-yellowing |
